Grizzly G0621X, Руководство пользователя

Страница: 46 / 64

-44-
Model G0621X (Mfd. Since 07/17)
Servicing V-Belts
3. Use a flashlight to inspect the belt.
— If a V-belt is cracked, frayed, or glazed,
replace it as soon as convenient.
4. Replace the pulley cover, lower wheel, and
blade; then close the lower wheel cover.
To ensure optimum power transfer from the motor
to the blade, the V-belts must be in good condi-
tion and operate under proper tension. Check belt
tension at least every 3 months—more often if the
bandsaw is used daily. V-belts stretch with use
and must be periodically re-tensioned.
Replace the V-belts if they are cracked, frayed, or
excessively worn.
Accessing V-Belts
1. DISCONNECT BANDSAW FROM POWER!
2. Open the lower wheel cover.
3. Remove the bandsaw blade.
4. Remove the lower wheel by removing the
hex bolt at the center of the wheel, then
sliding the wheel off the shaft. (The hex nut
has left handed threads, so you must turn it
clockwise to loosen it.)
5. Take off the pulley cover plate by removing
the six Phillips head screws. You now have
access to the V-belts for inspection or service
(see
Figure 54).
Checking V-Belts
1. Follow all previous instructions for Accessing
V-Belts.
2. Push the center of each V-belt as illustrated
in
Figure 55, using moderate force. When
tensioned correctly, the deflection should be
about
1
⁄
4
".
— If the deflection is more than
1
⁄
4
", then ten-
sion that V-belt (see Page 41) before doing
Step 4.
Pulley
Deflection
Pulley
Figure 55. Belt deflection.
Wheel
Pulley
Figure 54. Pulleys and V-belts.
Motor
Pulley
Idler
Pulley