Model G0602/G0752 (Mfd. Since 03/17)
-37-
Removing Center from Spindle
To remove the center from the spindle, insert a
piece of round bar stock or similar tool through the
outboard end (on the left side of the headstock).
Have another person hold onto the center with
a gloved hand or shop rag, then tap the center
loose.
To mount a center in the tailstock:
1. DISCONNECT LATHE FROM POWER!
2. Thoroughly clean and dry the tapered mating
surfaces of the tailstock quill bore and the
center, making sure that no lint or oil remains
on the tapers.
Mounting Center in Tailstock
The included dead center or a live center can be
used in the tailstock. Mounting instructions are
the same for both.
Figure 44 shows an example
photo of a dead center mounted in a tailstock.
Figure 44. Example photo of using a dead
center installed in the tailstock.
To avoid premature wear of the dead center
or damage to the workpiece, use low spindle
speeds and keep the tip of the dead center
mounted in the tailstock well lubricated.
3. Use the quill handwheel to feed the quill out
of the casting approximately 1" (see
Figure
1).
Note:
The maximum quill travel is 2
1
⁄
2
", but
we do not recommend extending the quill
more than 2" or stability and accuracy will be
reduced.
Figure 1. Dead center inserted into tailstock.
4. Insert the center into the tailstock quill.
5. Seat the center firmly into the quill during
workpiece installation by rotating the quill
handwheel clockwise to apply pressure, with
the center engaged in the center hole in the
workpiece.
Note:
Only apply enough pressure with the
tailstock quill to securely mount the workpiece
between centers. Avoid overtightening the
center against the workpiece, or it may
become difficult to remove later, and it will
result in excessive friction and heat, which
may damage the workpiece and center.
6. Secure the quill lock lever and tailstock lock
nut.
Removing Center from Tailstock
To remove the center from the quill, hold onto it
with a gloved hand or shop rag, then rotate the
quill handwheel counterclockwise to draw the quill
back into the casting until the center releases.
Dead Center
Содержание G0602
Страница 4: ... 4 Model G0602Z G0752Z Mfd Since 06 17 ...
Страница 95: ...Model G0602 G0752 Mfd Since 03 17 89 SECTION 10 APPENDIX machine G0602 Charts ...
Страница 96: ...G0752 Charts ...
Страница 100: ......