-18-
Model G0572 (Mfd. Since 01/21)
Table-Top Mount
Hanging Mount
You can use the air filter unit as a portable air
filtration system by installing the rubber feet and
placing the unit on a workbench or a table.
To make the unit operate at the optimum height
of 7' from the floor, you can install the air filter
unit in your shop by hanging it by chain, cable,
or steel strapping.
Tools Needed
Qty
Chain, Cable, or Steel Strapping ....... 4 Lengths
Phillips Screwdriver #2 ...................................... 1
Open-End Wrench 12mm .................................. 1
To set up air filter for table-top operation:
1. With help of an assistant, carefully invert air
filter unit.
2. Expose sticky backing on rubber foot and
apply foot to bottom of air filter unit (see
Figure 11). Repeat for each foot.
Note: For permanent table-top mounting, refer
to the Flush Mount procedure on
Page 19, and
install the air filter unit to the tabletop with the flush
mount flange brackets.
Figure 11. Rubber feet correctly installed.
To install air filter for hanging mount
operations:
1. Install (4) chains, cables, or steel strapping
lines to ceiling from capable ceiling joists
or supports so lines hang 15
1
⁄
4
" left-to-right
and 24
1
⁄
2
" front-to-rear and air filter hangs 7'
above floor when finished.
ONLY mount the air filter unit to joists or
table that can hold at least 100 lbs. DO
NOT mount the unit only to sheet rock,
pressboard, paneling, or honeycomb wall
panels with expansion-type fasteners. The
fasteners can tear out and the air filter can
fall. Ignoring this caution can result in injury
or property damage.
This machine and its
components are very
heavy. Get lifting help or
use power lifting equip-
ment such as a forklift to
move heavy items.
Rubber
Feet
Flange Bracket
Mounting Holes
