Grizzly G0543, Инструкция

Страница: 1 / 73

INTRODUCTION
The Model G0543 is the same jointer as the
Model G0500 with the upgrade of the spiral
cutterhead.
The spiral cutterhead consists of 40 indexable
carbide inserts. Each insert has four cutting
edges, which can be easily rotated if the current
cutting edge becomes dull or damaged.
In addition, a reference dot is in one corner of
each insert face to indicate when that insert has
been rotated. After all four edges have been
used, the dot will be back to its original position
and replacement of the insert will then be
necessary. Note—To avoid confusion about
which edges are sharp, always rotate inserts
clockwise. The inserts are not resharpenable.
INVENTORY
For the Model G0543, use the inventory list from
the Model G0500, but exchange the standard
cutterhead parts for the parts below:
Flat-Head Torx Screws....................................10
Torx Screw Driver T-Handle 6mm ....................1
Torx Bits T20 ....................................................5
Carbide Inserts ..................................................5
REPLACING or ROTATING INSERTS
To replace or rotate the inserts:
1. Disconnect the machine from the power
source.
2.
Clean out the heads of the insert Torx screws
that you wish to replace or rotate.
3. Remove the Torx screw, replace or rotate the
insert, lubricate the threads of the Torx screw
with a light machine oil, and torque the screw
to 50 inch pounds.
INSTRUCTION SHEET
Model G0543
8" Spiral Cutterhead Jointer
Figure 2.
Indexable carbide insert.
Figure 1.
Spiral cutterhead.
NOTICE
Make sure there is no wood dust or debris under
insert when replacing it.
NOTICE
Over-tightening Torx screws may strip the
cutterhead threads!