Grizzly G0542, Инструкция по эксплуатации

Страница: 16 / 32

-14- G0542 48" Pan and Box Brake
Aligning Fingers
Finger alignment is critical to the results you
will get with the bender during operation. The
fingers can be aligned individually or all at once.
(If you removed all the fingers for cleaning, fol-
low the instructions for aligning all of them at
once. Otherwise, just align individual fingers as
needed.)
Tools Needed: Qty
8MM Hex Wrench .............................................. 1
To align the fingers:
1.
Make sure the clamping handles are not
engaged, so that there is no pressure on the
fingers.
2.
Turning both setback knobs evenly, move
the bending leaf up so the bending wing is
approximately perpendicular to the fingers
(see
Figure 16 ); this will act as a straight-
edge. Refer to page 18 to set the stop col-
Figure 16.
Bending wing moved approximately
perpendicular to fingers to act as a straightedge.
Figure 17. One of two setback knobs, which are
located at the rear of the brake.
3. Using both setback knobs at the rear of the
brake (
Figure 17
), adjust the fingers forward
in even amounts until the forward-most finger
is barely touching the bending leaf.
Bending Wing
Figure 18.
Cap screws used to align fingers.
Setback
Knob
4. Loosen the three cap screws shown in
Figure 18
to align the fingers.
Note— To align all the fingers at once, loosen the
three cap screws on EACH finger and adjust the
setback forward until there is a small amount of
pressure from the fingers to the bending wing.
5.
Tighten the cap screws when the fingers are
aligned.