Grizzly G0504, Руководство пользователя

Страница: 41 / 76

G0504 16" Horizontal Resaw Bandsaw -39-
5. On the side that the belt tracks away from,
turn the front adjustment nut clockwise half
of a turn, and watch the belt tracking.
— If the tracking was not corrected by this
adjustment, repeat
Step 4
.
6.
When the conveyor belt is tracking in the
center of the roller brackets, run the con-
veyor for at least two minutes to ensure that
it will remain tracking correctly.
7. Tighten the rear adjustment nuts against the
bracket plates, then tighten the front adjust-
ment nuts against the bracket plates to make
sure that the tracking adjustment will not
slowly change during normal operation.
Replacing Conveyors
Although the conveyor belts have slight differenc-
es in size and access, the replacement instruc-
tions are the same.
To replace the conveyor belts:
1. Start the conveyor belt that you want to
replace.
2.
Stop the conveyor belt when the conveyor
belt seam (see Figure 41 ) is accessible.
Figure 41. Conveyor belt seam.