Grizzly EXTREME G0513X2B, Руководство пользователя

Страница: 13 / 104

Model g0513X2B (Mfg. since 5/11)
-13-
(Replaces Aligning
Fence on Page 31)
NOTICE
adjusting the fence parallel to the miter slot
does not guarantee straight cuts. the miter
slot may need to be adjusted parallel to the
side of the blade. refer to the "aligning
table" instructions on g0513X manual page
30.
to ensure cutting accuracy when the fence is first
installed, the fence should be aligned with the
miter slot.
to align the fence parallel with the miter slot:
1. disConneCt BAndsAW FroM poWer!
2. Make sure the miter slot is aligned with the
bandsaw blade (refer to
aligning table on
g0513X Manual page 30).
3. if the fence is mounted on the left-hand side
of the blade, remove it and remount it next to
the miter slot.
4. loosen the knobs and cap screw that secure
the fence rail to the table (see figure 3 on
page 10).
6. tighten the knobs and cap screw that secure
the rail to the table, being careful not to move
the fence.
figure 8. example of fence square with miter
slot.
5. Adjust the fence face parallel with the edge of
the miter slot, as shown in figure 8.