Grizzly 9962ZX, Инструкция по эксплуатации

Страница: 15 / 80

G0445/G0582/G9962Z/9962ZX Wide Belt Sander -13-
The following list outlines the electrical phase and
voltage required to operate the various sander
models, as well as the amperage draw of their
motors.
Note:
If you do not have three-phase
power available, you will have to install a phase
converter such as the Griz
zly Phase Converter.
Amperage Draw Specifications:
G9962Z—220V, Single-Phase ~60 Amp
10 HP Sanding Motor ............................50 Amps
1 HP Feed Motor .....................................7 Amps
1
⁄
3
HP Table Motor ...................................3 Amps
G9962ZX—220V, Three-Phase ~30 Amp
10 HP Sanding Motor ............................25 Amps
1 HP Feed Motor ..................................3.4 Amps
1
⁄
4
HP Table Motor ...............................1.2 Amps
G9962ZX—440V, Three-Phase ~15 Amp
10 HP Sanding Motor .........................12.5 Amps
1 HP Feed Motor ..................................1.7 Amps
1
⁄
4
HP Table Motor .................................0.6 Amp
G0582—220V, Three-Phase ~30 Amp
10 HP Sanding Motor ............................25 Amps
1 HP Feed Motor ..................................3.4 Amps
1
⁄
4
HP Table Motor ...............................1.2 Amps
G0582—440V, Three-Phase ~15 Amp
10 HP Sanding Motor .........................12.5 Amps
1 HP Feed Motor ..................................1.7 Amps
1
⁄
4
HP Table Motor .................................0.6 Amp
G0445—220V, Three-Phase ~30 Amp
10 HP Sanding Motor ............................25 Amps
1 HP Feed Motor ..................................3.4 Amps
1
⁄
4
HP Table Motor ...............................1.2 Amps
G0445—440V, Three-Phase ~15 Amp
10 HP Sanding Motor .........................12.5 Amps
1 HP Feed Motor ..................................1.7 Amps
1
⁄
4
HP Table Motor .................................0.6 Amp
Hard wire this machine to a power panel that can
safely supply power to your machine, that has
the proper overload protection,
and has a locking
shut-off lever (
Figure 6
). If you are unsure about
electrical wiring, consult a qualified electrician
before attempting any wiring.
220V/440V
Connection
SECTION 2: CIRCUIT
REQUIREMENTS
Do not use an extension cord with 220V/440V
machinery. An extension cord increases the risk
of electrocution and fire. Instead, position your
equipment near the power supply to eliminate the
extension cord requirement.
Extension Cords
Grounding
Electrocution or fire may
result if machinery is incor-
rectly grounded or the
power supply violates local
and state codes. Contact
a qualified electrician for
safe wiring practices!
Figure 6. Locking Shut-Off Lever.
Amperage Loads