English
23
6.4 DMX functions monochrome
Parade
can operate without DMX signal (in AUTOMATIC mode) and can be set so that a single MASTER unit will
command a series of SLAVE units. This function is particularly useful when more units are desired to execute the
same programme in synchrony.
The following picture shows an example of a Master-Slave layout.
7.1 MASTER configuration with infrared remote control
The projector can perform a pre-set colour-changer programme.
In order to perform such pre-set programme please refer to the chart below:
Attention!
In absence of DMX signal the led will remain ON.
Channel Function
Value
Description
1
Dimmer
Strobe
0-15
Luminous output intensity 100%
16-150
Proportional control of the luminous output intensity 100-0%
151-160
Luminous output intensity 0%
161-255
Proportional control of the strobe effect 0-100% (255=max)
7.0 Master-Slave and Automatic function
MASTER
SLAVE 1
SLAVE N
IN
OUT
IN
OUT
SLAVE 2
IN
OUT
Terminal resistor
120 Ohm
Funzione
Tasti
Descrizione
Master Con-
figuration
AV
the input or the removing of the automatic mode can be performed only after
the log in. The programme is: green-cyan-blue-magenta-red-yellow-white. The
pre-set time of each scene is 5 seconds. If the projector is turned off when it is set
in automatic mode, it will switch on again in automatic mode with the same se-
lected scene time.
Increase of
the scene
duration
P+
Available only if the projector is set in automatic mode. Increase of the scene
time: 5 – 10 – 20 – 40 seconds.
Decrease
of the
scene du-
ration
P-
Available only if the projector is set in automatic mode. Decrease of the scene
time: 40 – 20 – 10 – 5 seconds.
