1.0 PACKING
Check carefully the content of the box and in case of damage contact immediately your forwarder.
The following items are included in the box:
n° 1 5-Indexable rotogobo module;
n° 1 instructions leaflet;
n° 4 spacers
2.0 SAFETY
The 5-Indexable rotogobo module has been designed to be used exclusively with the PRO-
MOTION 1200 unit.
Before proceeding with any operation (e.g., before installing accessories) on the unit, disconnect
the unit from mains supply, by unplugging it.
Caution: hot lamp.
3.0 INSTALLATION
3.1 Mounting position
To install the 5-Indexable rotogobo module in the PRO-
MOTION unit, follow these instructions:
1) Remove the upper cover: loosen the 2 side screws A
pict.1; (the cover will remain linked to the unit by
means of a little wire);
2) Release the 2 clips (B pict.1); the rods will be posi-
tioned vertically by means of a spring.
3) Fit the 5-Indexable rotogobo module inside the unit.
Make sure that the green colored references on the unit
correspond to the green colored references on the
module; the holes (C pict.1) are to be assembled with
the fixing points located on the unit;
4) A protrusion is located in the 5-Indexable rotogobo
module lower part. This protrusion fits into the apposite
seat, which is placed in the unit's base (see pict. 3).
5) Lower the closing rods and rotate one quarter of a
turn the clamping clips.
6) Connect the flat power supply cable (pict.2) to one
of the power supply terminals located in the unit (E
pict.1).
NOTE: the power supply terminal must always be plug-
ged (when the unit is on), or unplugged (with the pro-
jector switched off).
7) Close the upper cover paying attention to the binding
clamps which supply the fans with power. The binding
clamps have to be assembled as per picture on the side
(F pict.1). Then ensure that the fans work properly.
7
Fan power
supply bin-
ding-clamps
pict.1
pict.2
