Griven AL4750, Инструкция по эксплуатации

Страница: 20 / 24

6.4 Connection to DMX lines
The unit is fitted with pins for the connection of the cables, as shown in the following pictures.
The connection of the cable to the unit must be performed respecting the label next to the terminal box of the
splitter.
6.5 Powering up the unit
After performing all the actions described in the previous paragraphs, it is possible to proceed and power up the
unit. In case of DMX signal connected, the LED will be steady on, while in the absence of DMX signal the LED will
be off.
7.1 Product description
IP65 2 ways DMX splitter is a 2 ways DMX splitter, features one DMX input/THRU and 2 DMX outputs.
This unit takes the incoming DMX signal and splits the signl into 2 separate output channels. Each output channel
and the input channel are completely electronically isolated from each other, all channels have independent
line drivers to boost the DMX signal.
7.0 Use of the unit
Warning!
All data wires must be isolated one from another, from the shield and from the metal housing of the connectors.
Pin number 1 of the housing is not to be connected to the electric ground of the unit.
Insert a terminal plug with a 120 Ω resistor connected to pins 2 and 3 in the last unit.
Lin
e
2
Lin
e
1
Main cables size
D+ D- Dc
DMX out2
D+ D- Dc
DMX out1
D
a
ta
+
D
a
ta
-
G
N
D
D
a
ta
+
D
a
ta
-
G
N
D
ø4,5 MIN
ø10 MAX
Pin 1: GND
Pin 2: DATA-
Pin 3: DATA+
20 English