GUBELLINI di D. Gubellini – Via Fiorentina 3508/H, 40059 Medicina BO – Italy – PI 02132331204 – CF GBLDGI75L02A944H
WEB: www.gripone.com – Email: [email protected]
8.
Disconnect the USB
3.0 Remote control standard connected to GRIPONE 2
The remote control standard must be connected to the connector number 4. The red led inform the
user about the state of ECU. The lever switch permit to adjust (in real time) the sensitive of ECU.
Moving the lever (from position 1 to 2) the user reduce the sensitive of ECU. The amount of variation is
equal to 2 steps of parameter SPINNING. (Ex. SPINNING = 2 and remote control ON is equal to
SPINNING = 4 and remote control 1).
Moving the lever to position 1 the red led will flash one time. Moving the lever to position 2 the red led
will flash two time.
Move the lever switch to position 1 to obtain MORE sensitive.
Move the lever switch to the right 2 to obtain LESS sensitive.
To use the remote control standard the user must set the parameter REMOTE (in to the ECU) to value 1 (one). Please follow the steps below to
fix the ECU for remote control standard:
1.
Connect the remote control analog to the ECU
2.
Switch on the ECU
3.
Keep pressed the P button until all the red leds stay on
4.
Release the P button. The leds Parameters must be like this:
5.
Press one time the P button. The leds Parameters must be like this:
6.
Press the V button to set the value of parameter REMOTE to a 1 (one)
7.
Press one time the P button to come back to the standby mode.
8.
Switch off the ECU.
