15
14
Your pneumatic fastening tool has been designed for long life and trouble-
free operation. However, if operating problems arise, please use the
troubleshooting information below to determine how to remedy the prob-
lem.
TOOL TROUBLESHOOTING
Always disconnect tool from air supply before performing any service on
tool. Correcting a problem while the tool is pressurized may result in
injury from fastener drive or tool operation.
DANGER
MAINTENANCE
MAINTENANCE
Your tool will last longer and perform better if periodic maintenance is
performed. Please use the information below to keep your tool operating in
top condition.
Lubrication
Disconnect tool from the air supply and remove all
fasteners. Apply 3 - 5 drops of air tool oil (provided) in
the air inlet two - three times a day. If the tool will be
used outside in the winter, use a winter grade air tool oil
to help keep frost from forming inside the tool. Do not
use other types of lubricants on this tool, as other
lubricants may contain chemicals harmful to o-rings
and other tool components. Drain compressor tanks
and hoses daily.
Cleaning
Disconnect tool from the air supply. Brush tool off using a parts cleaning
brush or clean rag. Check area around trigger and safety lever, and clean
as necessary. Open magazine, remove all fasteners, and brush out
grooves and fastener track. Remove nose plate, and blow out hard to
reach areas in tool nose using low pressure compressed air.
TOOL CHECKS
Keep your nailer in top working condition by checking it daily. See your
Grip-Rite™ dealer for service if part or operating problems are found. Never
use a malfunctioning tool - it could result in serious injury.
Daily Inspection
• Check for broken, damaged, or excessively worn parts, and repair
or replace as needed.
• Check for air leaks at trigger, cap, and nose. Disconnect tool from
air supply immediately if leaks are present, and see dealer for
service.
• Make sure all screws are tightened securely.
Always disconnect tool from air supply before performing any service on
tool. Correcting a problem while the tool is pressurized may result in
injury from fastener drive or tool operation.
DANGER
TROUBLESHOOTING
MAINTENANCE
Fasteners do not drive
completely.
Increase air pressure. Do not exceed 100
psi. Add 2 - 3 drops of air tool oil to inlet.
PROBLEM
CORRECTIVE ACTION
Fasteners do not drive
completely after air
pressure is increased.
Driver blade worn or broken. See dealer for
replacement.
Tool leaks air.
Check for source of leak, and tighten fittings
and screws as required. Discontinue using
tool if air leaks after tightening. Contact your
dealer for service.
Fasteners do not drive
completely when
driving in quick succes-
sion.
Inadequate air flow. Use larger diameter hose.
Use compressor with larger storage tank.
Keep hose lines short. Check air hose for
kinks or other restrictions.
Fasteners drive too
deeply.
Reduce air pressure. (Do not reduce air
pressure below 70 psi.)
Tool operates, but no
fastener is driven.
Check fasteners for smooth feeding in
magazine. Check magazine for obstructions
or debris, and clean as required.
FASTENER DRIVING PROBLEMS
