Baserunner Controller User Manual
Rev 1.0
2 Connectors
The V4
Baserunners
achieve maximum versatility with minimal wiring. A pair of
+- battery leads supply power, a single overmolded cable carries all motor
signals, and three waterproof signal plugs support a range of hookup strategies.
2.1 Battery Leads
The short 5cm leads for the battery pack emerge on the
back end of the controller. When supplied with a
downtube battery these leads will be soldered to the
mating cradle connectors, while they may be
unterminated or fitted with Anderson Powerpoles when
purchased alone.
2.2 Motor Cable
The motor connection has 38cm lead to either a HiGo L1019 connector or a
Z910 connector depending on the model. This length is sufficient to reach a rear
hub motor on most bikes with the controller mounted on the downtube or seat-
tube. Front hub installations are supplied with a 60cm motor extension cable.
Baserunner_L10 Motor Plug Pinout
The Higo L1019 cable has three motor
phase pins capable of 80 amps peak,
along with 7 small signal wires for hall
position, speed encoder, and motor
temperature.
Baserunner_Z9 Motor Plug Pinout
The Z910 cable has three motor phase
pins capable of 55 A peak, and just 6
signal wires, 5 for the hall sensors and
the one additional wire can be either
motor speed, motor temperature, or
combined speed and temperature.
-4-
