Grin Technologies Frankenrunner, Руководство пользователя

Страница: 6 / 27

Frankenrunner User Manual
Rev 1.0
2.5 Mains Signals Plug
Mains Pinout
An alternate interface is provided via the 9 pin
Mains cable. This uses uses the Signal D 1109
Connector from Cusmade, and supports
conventional ebike wiring strategies for 3
rd party
display consoles. It shares many signals with the
CA-WP plug, but rather than using the shunt
resistor for current sensing, it has TX and RX pins
that communicate digitally to the display.
2.6 PAS / Torque Plug
PAS Pinout
Finally there is a 6 pin HiGo MiniB Z609 plug for
connection of a PAS sensor or Torque Sensor.
Note that the PAS 2 pin shares the same signal as
the Fwd/Rev input of the Mains cable, and can be
configured for either function. (See section 6.2 )
2.7 Communication Port
A TRRS jack embedded in the controller can be used for connecting to a
computer, Android smart phone, or potential Bluetooth dongle (future product).
The communication standard uses a 0 to 5V level serial bus. Grin produces a 3m
long TTL->USB adapter cable to connect the unit with the USB port of a standard
computer. This is the same communication cable used with the
Cycle Analyst
and Satiator products. Third party USB->Serial cables, such as FTDI’s part
-4-