File: LIQ User Manual V2.0
Page 30 of 37
A.5 Configuring an LIQ-60
1. Click
Device Config
to display and/or edit the LIQ description and measurement configuration.
Figure 11: A.5 Configuring a CMS
The user has the following configuration selection:
a)
Enter a 50 character description of the CMS Location into the
Device Description
field.
b)
Select the
Position Number
of the conductor that the LIQ-60 is on. (E.g. 1-Phase A, 2-
Phase B, etc.)
c)
Select the number of the group that the LIQ-60 is in from the
Group Number
field.
d)
Select the
Position Number
of the conductor that the LIQ-60 is on. (E.g. 1-Phase A, 2-
Phase B, etc.)
e)
Enable
Load Logging
f)
Enable
Fault Detection Event
recording
g)
Enable
Power Factor Logging.
Should the user select No, the CMS will return only
instantaneous data rather than logged readings.
h)
Enable
Temperature Logging
.
i)
Select data polling interval (log average in minutes). Selecting a higher polling rate will
decrease the log capacity, as the available memory will reduce. However, the most recent
data is always retained.
Содержание Line IQ LIQ60
