GRIDIRON Multi-Purpose Portable Table
Instruction Manual
9
SECTION 3: INSTALLING THE TABLE AND
RAIL OF THE EX-TRACK
®
CNC UNIT
SECTION 3�
INSTALLING THE TABLE AND RAIL OF THE EX-TRACK
®
CNC UNIT
Follow these steps:
1� Move the table to the chosen location using the casters, then secure it in place by pushing
the caster pedal brakes all the way down with your foot to prevent the casters from moving�
2� Remove the four M14 screws from the EX-TRACK
®
CNC rail holder using a 12 mm hex key�
3� Place the rail on the holder (the toothing on the rail must be on the grid side) and fasten it
with the enclosed four M14 screws using a 12 mm hex key�
4� Install the CNC unit according to the instructions provided in the manual for EX-TRACK
®
CNC�
5� Connect a hose to the drain valve or insert it into the tank from above through the grid and fill
the tank with water no higher than 3 cm from the top of the tank�
6� If you fill the tank through the valve, close the valve once the tank is filled�
7�
Required tools: Hex key with 12 mm diameter�
