Installation Guide:
Step 1 :
Press the U-bracket firmly against
the mounting surface. Tighten the
screws by turning them clockwise.
See Figure-I.
Step 2 :
Line up the U-bracket and the speaker
and turn the knob above clockwise first
before turning the knob below. DO NOT
tighten the knobs completely. See
Figure-II.
Step 3 :
Remove the terminal cover. Insert the
wire through the centre hole of the
cover and connect it to the terminal
block. See Figure-III.
Step 4 :
Replace the terminal cover behind the
speaker. Select the right wattage using
a screwdriver. See Figure-IV.
Step 5 :
Adjust the angle of the speaker to
achieve
the
most
efficient
broadcasting effect. See Figure-V or
Figure-VI. Tighten the knobs to
ensure a firm fitting.
PAW – 7000AS50W
