GreenWorks LMF401, Руководство оператора

Страница: 7 / 8

5.4 STORE THE MACHINE
• Clean the machine before storage.
• Make sure the motor is not hot when you put the machine
into storage.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
You may lower the handle(s) before you put the machine into
the storage.
1. Fully loosen the handle fasteners on the sides of the
handle(s).
2. Fold away the handle(s).
3. Do not pinch or trap the cables.
6 TROUBLESHOOTING
Problem Possible cause Solution
The handle is not
in position. The bolts are not
engaged correctly. Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The machine does
not start. The battery ca-
pacity is low. Charge the battery
pack.
The bail switch is
defective. Replace the bail
switch.
The battery key is
not put in. Put in the battery
key.
The machine cuts
grass unevenly. The lawn is rough. Examine the mow-
ing area.
The blade height is
not set correctly. Move the wheels
to a higher posi-
tion.
The machine does
not mulch correct-
ly. Wet grass clip-
pings attach to the
deck. Wait until the
grass dries before
mowing.
The mulch plug is
missing. Install the mulch
plug.
The machine is
hard to push. The grass is too
tall, or the blade
height is too low. Increase the blade
height.
The grass catcher
and the blade
drags in thick
grass. Empty the grass
clippings from the
grass catcher.
Problem Possible cause Solution
There is a high vi-
bration in the ma-
chine. The blade is un-
balanced and
worn. Replace the blade.
The motor shaft is
bent. 1. Stop the mo-
tor.
2. Remove the
safety key and
battery pack.
3. Disconnect the
power source.
4. Inspect for
damage.
5. Repair the ma-
chine before
you start it
again.
The machine stops
during mowing. The blade height is
too low. Increase the blade
height.
The battery pack is
out of power. Charge the battery
pack.
The grass clip-
pings attach to the
deck or the blade. Remove the bat-
tery pack and
check the deck.
Operation temper-
ature of the ma-
chine is too high. Cool the machine.
* If you cannot find the solution to these problems, go to the
service center.
7 TECHNICAL DATA
Voltage 40 V
No load speed 2800 / min
Cut width 460 mm
Cut height 25 - 80 mm
Grass catcher ca-
pacity 55 L
Weight (without
battery pack) 24 kg
Measured sound
pressure level L
PA
= 81.8 dB(A), K= 3 dB(A)
Guaranteed sound
power level L
WA.d
= 96 dB(A)
Battery model 29727 and other BAF series
Charger model 29417 and other CAF series
Vibration < 2.5 m/s², K=1.5 m/s²
IPX IPX1
7
English
EN