GreenWorks Pro 2401307, Руководство оператора

Страница: 5 / 121

1 DESCRIPTION
1.1 PURPOSE
The machine is used to propel air out of a tube to move
unwanted materials such as leaves in the yard. Some
machines also suck in leaves and small twigs through a
vacuum, and shred them into a bag.
1.2 OVERVIEW
Figure 1 - 4.
1 Trigger
2 Turbo button
3 Cruise control lever
4 Rear tube 5 Front tube
6 Tab
7 Groove
2 SAFETY
WARNING
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
3.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2 INSTALL THE BLOWER TUBE
Figure 2 - 3.
1. Align the grooves on the rear tube with tabs on the
blower housing.
2. Install the rear tube onto the blower housing until the
tabs engage the grooves.
3. Turn the rear tube in the direction of the arrow until
the two tabs lock into the positions.
4. Connect the front tube in the same procedure
above.
3.3 INSTALL THE BATTERY PACK
Figure 4.
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.4 REMOVE THE BATTERY PACK
Figure 4.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
WARNING
Make sure the blower tube is in position before
operation.
4.1 START THE MACHINE
Figure 1.
1. Pull the trigger to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.
4.2 STOP THE MACHINE
Figure 1.
1. Release the trigger to stop the machine.
NOTE
Wait until the engine stops after you stop the machine.
4.3 CRUISE CONTROL LEVER
Figure 1.
4
English
EN