GreenTec HXF 2800, Руководство пользователя

Страница: 15 / 27

HXF 2800 / 2802 AHS
15
Tool start
•
Choose low motor rpm
•
Make sure the area surrounding the tool is secure.
•
Warm start – Start the tool.
•
Cold start – never start at max rpm. Let the tool run unloaded for approx. 15 min to warm up
the oil.
•
Slowly increase the rpm until the proper oil flow is achieved.
•
Never try to restart an overworked tool. Always remove wedged and debris.
Tool stop
•
Reduce engine rpm to idle speed. Then stop the tool.
•
Never increase or decrease the amount of oil too fast. This can cause longer-term damage to
the hydraulic system
The cutting angle is as std. a “top-link”, and can only be adjusted when
the machine is stopped.
A hydraulically ram (option), can be mounted. Operate the ram in the
required direction to set the desired cutting angle before starting work.
The ram may be operated during work to make minor angling adjustments, but it is
recommended to stop work before making major adjustments to the cutting angle.
To prevent sawblades in blocking there is mounted a Branchcarrier part
no. 200112.0, a Plastic-strip part no. 200110.0 in the full length of the
machine and wearplates part no. 200153.0 under each sawblade to prevent sawblades
bending. If the sawblades anyway blocks, then stop the saw, stop the carrier, take out the
ignition key, pull the handbrake, take your safety goggles and gloves on and remove the
jammed piece of wood.