GreenTec 9991902C-25, Инструкция по эксплуатации

Страница: 56 / 76

FOX
MULTI
C
AR
R
IER
48
5.4.4 DRIVING INSTRUCTIONS
The FOX Multi Carrier must always be operated in the most appropriate way, so that the best possible result
is achieved during use.
It is important that the operator learns all the functions of both the vehicle, FOX Multi Carrier and attachment
tool as it is a combination of these that must control the overall result for e.g. cutting of fences / hedges.
FOX Multi Carrier must be controlled and set as follows:
1. Remove safety rivets from mechanical telescopic arm and attachment tool. The telescopic arm on
the FOX Multi Carrier is pulled out to the desired working width with the attachment tool mounted:
2. Refit the safety rivet on the telescopic arm, in one of the 3 holes:
•
FOX Multi Carrier can be set in 3 different levels
(See section on
: ” Adjusting the mechanical telescopic arm ” – page 50)
3. The direction of travel with the attachment tool must only go forward and follow the "fence" line:
•
The break-back protection system on the attachment tool is only activated in the forward
direction. (Always check the instructions for the
GreenTec attachment tool in use, on
www.greentec.eu )