Greenlee Tools, Inc.
9
Reel-X
™
Fish Tape
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Replace Reel cont.
5. Retrieve replacement reel cartridge.
6. Place pulling eye
(fig. 1, component 4)
through
desired exit in front housing
(fig. 1, component 1)
.
If using the primary exit: Make sure fish tape
material is placed inside of the front housing guide
wall and guide track. Failure to do so will increase
friction or potentially jam unit.
7. Cut and remove tie.
8. Place rear housing onto assembly, ensuring tabs on
housing inner diameters line up.
9. Screw the 4 screws
(fig. 1, component 7)
until tight.
10. Extend and retract fish tape material to ensure the
reel freely spins. If reel does not spin freely, check to
ensure tape is inside of guide wall and guide track.
Note: To switch exits (primary to secondary exit or
vice versa), follow all previous steps except instead of
switching out reels, move the pulling eye through the
other exit.
Tab
Guide Track
Guide Wall
Primary Exit
(fig. 1,
Feature A)
Secondary Exit
(fig. 1, Feature B)
Replace Storage Lock
1. Insert storage lock flange into opening. Flange
should slide underneath housing wall on the
locked position.
2. Make sure storage lock is flush with face of front
housing and slide back to the unlocked position.
Flange
Top View
Side View
Flange Housing Wall
