EHP700L Battery-powered Pump
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
7
Setup
Features of the Pump
• This pump is equipped with a brake, which stops the
forward motion of the piston/dies when the trigger is
released.
• The unit is equipped with a double piston pump,
which is characterized by a rapid approach of the dies
toward the connector and a slow crimping motion.
• All tool functions can be controlled by the rocker
trigger, resulting in easy handling.
• The pump is equipped with a microprocessor, which
indicates service intervals and low battery charges. It
also performs internal checks, sending out acoustical
and optical warning signals in case of a detected fault.
• The pump can be operated and transported in all
positions without any oil leakages.
• This tool is equipped with a circuit board, incorporat-
ing several important features to inform the user about
the current status of the unit.
• Before operating the pump, the charging level of the
battery should be tested. A low charging level can be
detected by the LCD display.
• The pressure units may be displayed in bar or psi.
To change the units, set the selection switch to 7,
depress the pendant toggle three times, and then hold
the toggle switch to change the display.
Hydraulic Connection
1. Clean all couplers, threaded fittings, ports, and the
area around all ports.
2. Remove any dust caps from couplers.
3. Hand-tighten all couplings firmly (until all threads are
fully engaged). Do not use tools.
