For best results use tap water.
Assembly Instructions for Hydropod Propagator
1. Place the reservoir on a level surface. Push the
bottom of the stand onto the pump and attach the
three suction pads. Push the sponge filter onto the
end of the pump. The lead should sit in the groove
on the edge of the reservoir.
2. Insert the adaptor on the spray assembly onto the
pump outlet. This is a tight fit to improve stability
when in use. Then push the pump onto the bottom
of the reservoir using the suckers.
Push the optional heater onto the bottom of the
reservoir using the suckers provided. Use the
additional instructions for operating the heater.
3. Fill the reservoir with water to the level of the spray
bars. Ensure the spray bars are level. Briefly test by
plugging the pump in. Either use luke warm water
or cold water from the tap which has been left to
reach room temperature.
4. Place the cuttings tray in position.
