Step 1 Fabra hood Form F 471322
Figure 2 Fabra hood Form F 471322
Step 1
Open the shipping crates and separate the parts according to the size of the unit, refer to Figure 1.
Step 2
Place the two BASE ENDS and the two BASE SIDES in their approximate relationship to each other, see Figure 2.
Fasten together using three 1/4-20 fasteners per corner for 5 inch high base and four 1/4-20 fasteners per corner for
12 inch high base.
Note: Fasteners should be hand tightened only until step 4.
On some units where the difference between the
hood width and throat width is greater than 32 inches, a REINFORCING PLATE is required in the corners of the
BASE, refer to Figure 2, Detail A.
Figure 2
Figure 1
®
Fabra Hood • Form F
1
®
Document 471322
Model FGI/FGR Fabra Hood
Form F - Single Section with Filters
Throat length less than or equal to 72 inches
Assembly Instructions
Please read and save these instructions for future reference. Read carefully before attempting to assemble, install,
operate or maintain the product described. Protect yourself and others by observing all safety information. Failure
to comply with these instructions will result in voiding of the product warranty and may result in personal injury
and/or property damage.
