Figure 7 Fabra hood Form F 471322
Step 9
Assemble HOOD PANELS
to HOOD RAIL ASSEMBLY.
The HOOD END ASSEMBLY
with the MALE RIB is to be
installed first see Figure 7,
Detail E. Place the remaining
HOOD PANELS in place,
interlocking panels as you
go, see Detail E. Secure each
HOOD PANEL to the HOOD
RAIL ASSEMBLY as it is put
in place using four 12 X 3/8
inch sheet metal screws with
sealing washers per HOOD
PANEL. The HOOD END
ASSEMBLY with the FEMALE
RIB is to be installed last.
NOTE: Hoods over 9 feet
wide are supplied with
special HOOD CLIPS.
See Detail F. HOOD
PANELS have predrilled holes for HOOD CLIP
installation. Install CLIPS as HOOD PANELS
are being put in place, using one 12 X 5/8 inch
sheet metal screw with sealing washer per
HOOD CLIP. To install CLIPS in the last panel,
remove the end FILTERS to provide access to
the underside of the hood. The FILTERS can
be easily replaced after the hood is completely
assembled.
Step 10 Fabra hood Form F 471322
Step 10
Tighten all pivot bracket fasteners.
NOTE: There may be extra fasteners.
Figure 7
471322 • Fabra Hood Form F, Rev. 4, August 2018
Copyright 2018 © Greenheck Fan Corporation
4
As a result of our commitment to continuous improvement, Greenheck reserves the right to change specifications
without notice.
Product warranties can be found online at Greenheck.com, either on the specific product page or in the literature
section of the website at Greenheck.com/Resources/Library/Literature.
®
Phone: 715.359.6171 • Fax: 715.355.2399 • Parts: 800.355.5354 • E-mail: [email protected] • Website: www.greenheck.com
Our Commitment
AMCA Publication 410-96, Safety Practices for Users and
Installers of Industrial and Commercial Fans, provides
additional safety information. This publication can be obtained
from AMCA International, Inc. at www.amca.org.
Greenheck's Gravity Ventilators catalog provides additional
information describing the equipment, fan performance,
available accessories, and specification data.
