Greencut GS7500, Инструкция по эксплуатации

Страница: 75 / 80

75
EN
4. Check the entire machine for leaks of fuel or grease.
5. Make sure the nuts, bolts and screws (except the carburetor adjusting screws) are tightened.
6. Clean any dirt or debris from the hedge trimmer blades.
7. Lubricate blades before use and after refueling.
8. Check that the blades are not damaged or that there is no incorrect adjustment.
9. Make sure the cutter attachment is securely fastened.
10. Keep the spark plug and cable connections tight and clean.
11. Clean all dirt and debris from the engine, check that the cooling fins and air filter are not clogged and clean them
if necessary.
NOTE: Under severe machine operating conditions (high temperatures, dusty areas, etc.), shorter
maintenance intervals are required.
TROUBLESHOOTING
Good maintenance will extend the useful life of the machine. Prolonged or regular use may require more intensive
maintenance so that the machine continues to function properly. The table includes some of the most common
problems, their causes and solutions. If the machine does not start:
ENGINE DOES NOT START
NOTE : If the engine still does not run, take the machine to an Official Service Facility.
PROBLEM POSSIBLE CAUSE SOLUTION
The engine won't start?
A. Retractable starter defective.
B. Fluid in the crankcase.
C. Internal damage.
Take the machine to an Official
Technical Service.
No good compression?
A. Spark plug loose.
B. Excessive wear of cylinder, piston,
rings.
Tighten and retest.
Does the tank contain no
fresh fuel or the correct
grade?
Incorrect, past, or contaminated fuel,
incorrect mixture. Fill the tank with the correct grade of
new fuel/oil mixture.
Is there a spark in the plug
terminal?
A. The power switch is in the “OFF”
position.
B. Short-circuit/earth problems.
C. The ignition unit is defective.
Move the switch to the “ON”
position and restart.
Check the spark plug.
A. If the plug is wet, there may be excess
fuel in the cylinder.
B. The plug is dirty or opened
incorrectly.
C. The plug is damaged internally or
incorrectly sized.
1. Unplug the motor crank handle,
reinstall the plug and restart.
2. Clean and replace the plug at
0.6mm-0.7mm and reset.