Part Nos:
LEDFLSPIR10W, LEDFLSPIR10B, LEDFLSPIR20W,
LEDFLSPIR20B, LEDFLSPIR30W, LEDFLSPIR30B, LEDFLSPIR50B,
LEDFLSPIR100B
This product should be installed by a competent person
and in accordance with the IET Wiring Regulations.
If in doubt, consult a qualified electrician.
These instructions should be read carefully prior to any
installation and retained after completion for further
reference and maintenance. Please give these instructions
to the building owner/occupier after installation.
Always turn off the power source before commencing work
on this device
INSTALLATION DIMENSIONS - FIGURE A (Unit:mm)
IMPORTANT INFORMATION
Installation Instructions for:-
‘Lynx’ Range
LED Slimline PIR Floodlights
INSTALLATION INSTRUCTIONS
This luminaire is water resistant to IP54 but it is advisable,
wherever possible, to locate it in a sheltered location. No
modification should be made to the casing to preserve the
moisture properties and warranty.
This appliance comes with a short length of flex and this
can not be removed or replaced in order to keep the
waterproofing benefits. The flex should be connected to a
waterproof connector if this is likely to be in an outside
location. To avoid a heat build up a clear air gap around
the luminaire and the front face should be at least 500mm
away from any combustible surface. The supplied bracket
should be used at all times for mounting.
Part No
L1
L2
L3
Ø1
Ø2
LEDFLSPIR10B/W
54.3
60.0
65.7
7.3
6.3
LEDFLSPIR20B/W
84.0
96.0
108.0
8.0
8.0
LEDFLSPIR30B/W
76.0
100.0
124.0
13.0
10.5
LEDFLSPIR50B
126.0
150.0
174.0
13.0
10.5
LEDFLSPIR100B
143.5
180.0
216.5
13.0
13.0
POSITIONING OF FITTING
Position of
fixing holes
on bracket
Figure A
