SAFETY PRECAUTIONS
INSTALLATION OF THE UNIT
PARTS DESCRIPTION
1
.
Read all the instructions carefully before using the appliance.
2
.
Remove the packages and ensure that the appliance is undamaged.
In case of doubt do not use the appliance and contact your supplier.
3
.
Do not let children play with parts of the packages (such as plastic bags).
4.
Do not install the automatic hand dryer on wooden or plastic walls.
5
.
Do not install the appliance within range of people using baths or showers.
6.
Before installing the unit, check that the electrical voltage of your main
supply corresponds to the voltage marked on the rating label of the appliance.
7
.
Before installing the appliance, check that there are no obstructions within
50
cm of the sensor.
8.
Do not install in places where there are gas, paint or other inflammable objects.
In case of malfunction or abnormal operation, turn off, unplug it from the socket-
outlet and send the appliance to the service centre for repair and inspection.
9
.
Before maintenance or repair, make sure that the unit is unplugged.
10
. Do not insert any objects into the appliance.
11
. Prevent water from getting into the housing of the appliance during operation or
in storage. Hazard of electric shock, always store in dry area with no moisture.
12
. Do not use outdoors
13
. The appliance is not intended for use by young children or infirm persons
without supervision.
14
. Young children should be supervised to ensure that they do not play with
the appliance.
1
.
Any servicing other than cleaning and user maintenance should be performed by
authorised service representative.
2
.
Do not splash the unit with water. To reduce the risk of fire or electric shock,
do not remove the housing. No user serviceable parts inside.
Only authorised service personnel shall handle repair work.
3
.
If the supply cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent.
•
The automatic hand dryer must only be installed by a qualified electrician in
compliance with latest regulations.
•
After installation or servicing, units must be checked and only left where
electrically and mechanically safe.
1
.
Remove the fixing screw from front enclosure by screwdriver (Fig
1
) and take out
the front enclosure.
2
.
Stick the installation instruction card (Fig
2
) to the wall where you want to
fix the unit, then drill four holes with a diameter
6.5
mm through the instruction
card.
3
.
Insert rawl plugs provided into the holes and knock them in with a hammer,
then remove the instruction card.
4
.
Make sure that the air outlet is facing downwards and fix the base of appliance to
the wall with fixing screws provided.
5
.
Remove the P.C.B upper cover and adjust the sensor to required setting (Fig
3
).
6
.
Replace the front enclosure to the base of the unit with the fixing screw removed
at the beginning (Fig
4
).
7
.
Wire the unit into a suitable power supply via a fused RCD spur unit. The hand
dryer is now read to use.
CAUTION
