1
. Open the cover of the Magnetic
sensor with a flat screwdriver. A
gentle twisting will remove the
cover of the sensor.
2
. Insert two size “AAA” alkaline
batteries in the sensor, observ-
ing the polarity.
3
. Set the house codes (
1-16
)
inside the sensor, it must be
matching with the code set in
the receiver.
4
. Set
3
position slide switch to
selected tune (see diagram
2
)
Note: different sensors can all
be set to different tunes if
required.
5
. There is a test switch at the
back for testing with receiver
before mounting.
6
. Locate the sensor and the
magnetic piece (see dia
1
) on
the opening such as door or
window. Do not mount the
sensor on a metal surface.
7
. Mount the back plate on a
desired area with the
2
screws
supplied. Select a mounting
location no further than
50
m
from the receiver, actual
working range depends on the
number of walls that the signal
has to pass through.
8
. Place the back plate in the right
position, drill two
4
.
76
mm
holes and insert the wall plugs,
then tighten the plate on to the
wall with the screws (dia.
2
.
6
x
26
mm) supplied.
9
. Position the sensor over the
back plate so that the lip on the
back plate engages into the slot.
INSTALLATION
•
Wireless Magnetic Sensor
(Door/Window Alert)
•
For use with wireless Doorchimes
•
433
MHz,
16
code settings
•
Up to
50
M range
•
2
x “AAA” Batteries
•
Indoor use only
•
CE - EMC / LVD / R&TTE approved
•
RoHS compliance
DW
081
A-C
Security Window Sensor
