MODEL NUMBERS:
DW040A: Ambassador wirefree kit
DW040AG: Ambassador wirefree kit
DW040AS: Ambassador wirefree kit
DW041A: Ambassador receiver only
DW050A: Beacon Wirefree Kit
DW051A: Beacon wirefree receiver
• No more wires
• Simply insert batteries
• Batteries included for Transmitter
(2 x AAA)
• Receiver requires three Alkaline
”C cell“ LR14 batteries
• Transmitter screws included
Please read the instructions fully
before attempting installation.
1a) TRANSMITTER
The battery compartment slot is
located on the bottom of the unit.
Using a flat screw driver insert into slot
and gently push to remove the lower
cover. Insert the two AAA batteries
supplied and refit the base cover.
1 b) RECEIVER
The battery compartment is located
on the base.
Remove cover gently by pushing and
releasing the two tabs.
Insert three batteries, ensuring the
correct polarity so that the negative
end is always resting on the spring
and the positive end on the flat metal
plate.
The first battery goes in the lower
compartment with the negative end
against the spring.
The other two are inserted as shown
in diagram 4. above.
Replace battery cover carefully.
Press the button on the transmitter
Diag. 1.
Transmitter
Diagram 2. Receiver
Diagram 4.
Receiver
(cross section)
Skip to section 5 unless you wish
to change the factory set tune,
volume or house codes.
WIREFREE DOORCHIMES
Diagram 3.
STEP 1. TESTING THE
TRANSMITTER AND
RECEIVER WITH BATTERIES
STEP 3. TUNE SELECTION &
VOLUME CONTROL
(FLASHING LIGHT ONLY AVAILABLE
ON MODELS DW050A AND DW051A)
STEP 2. INSTALLING
THE TRANSMITTER TO
THE DOOR
and the doorchime will sound.
You have now tested your doorchime.
If there is no sound, check that
batteries are inserted correctly and
that they are not exhausted.
Before drilling any holes
position the
transmitter on the door or door frame
outside (ideally a flat wooden area)
and press the button to ensure the
signals are getting through to the
receiver. Please test with the door
closed to simulate actual working
conditions. You should also look to
position the transmitter in an
unexposed place to protect from rain.
The range of the unit is up to 100
metres but mounting the transmitter
on metal or UPVC doorframes may
make the unit inoperative or seriously
reduce the operating range.
As with all low powered transmitters
the number of walls and ceilings the
signal has to travel through, between
the transmitter and receiver also
affects the range.
Once a suitable surface is found
remove the transmitter base follow-
ing 1a).Use this as a template to fix
the base on to a doorframe. Ensure
the transmitter is the right way up so
that the slot is at the bottom.
If mounting on to masonry, wall fixings
will be required. Refit unit to the base.
IMPORTANT : The screws must be
fixed flush or the battery will not
maintain contact with the terminals
and the unit will not operate.
TUNE SELECTION
The unit comes with a factory pre-set
tune but it can be changed.
The tune is determined by the slider
switch as in Diagram 3.
Remove transmitter cover as in 1a)
above
leaving the battery in
and
select tune as shown in Diagram 3.
Press the push button to hear the
sound each different setting produces.
Once a desired tune is selected,
Carefully replace transmitter. Up to 3
different sound options are available.
