Greenberry 14806, Инструкция по эксплуатации

Страница: 6 / 15

6
VENETO-40 - Instructions for use
IMPORTANT:
The Importer/Supplier bears no responsibility for damages resulting from
inappropriate installation, application of inappropriate components, technical
modifications and failure to comply with these instructions.
II. APPLIANCE DESCRIPTION (Img.1):
A - Front protective mesh
B - A nut for fastening the propeller
C - Propeller
D - A nut for fastening the guard
E - Fixing lock
F - Rear protective mesh
G - Engine
H - Control panel, airflow control switch:
- „0” - device disabled
- „1” - gentle airflow
- „2” - medium airflow
- „3” - strong airflow
I - Engine casing
J - Adjusting knob
K - Screw “A”
L - Screw “B”
M. - Base cover
N - Extension of the stand
O - Height-adjustment ring
P - Stand
Q - Base
III. ASSEMBLY:
ATTENTION:
Turn the device off and unplug it before you replace/assemble any parts.
1. Assemble the base cross (Q), unscrew and take out four screws (K) from both parts of the base, and
then cross them. Place the stand (P) on the assembled base, adjusting it so as to make the openings in
the flange of the stand coincide with those in the base, then tighten up the four screws (K) and place the
guard of the base from above (M) (Img.2).
2. The back protective mesh (F) should be put at the front of the motor part and fixed by screwing the nut
for fastening the guard (D) (Img.3).
3. Place the propeller (C) on the axle of the engine and fasten it by tightening up the nut (B) (Img.4).
4. Put the front protective mesh to the previously fixed back protective mesh in such a way as to make
their edges coincide, then join the front guard with the back one by means of four snap fasteners (E)
(Img.5).
5. Take out the extension tube (N) from the stand to a suitable height and screw the elements together,
using the height-adjustment ring (O) (Img.6).
6. Place the assembled body of the fan on the extension of the stand (N) and fasten it using the screw (L)
(Img.7).