5
REGISTRATION FORM
Complete and return Warranty Card.
Your powerhead has a model/serial number decal located on the muffler
side of the engine. Record this number and the model number in the space provided on page 2 of this manual.
You will need these numbers if you order parts.
SPARK PLUG INSTALLATION
If your powerhead does not have the spark plug already installed for you. You will have to install it following the
instructions given below.
1. Locate the spark plug in the parts packet.
2. With powerhead laying on side labeled “THIS SIDE UP WHEN NOT IN USE,” place spark plug in spark plug hole.
NOTE: A resistor spark plug must be used for replacement.
3. Turn by hand until snug.
4. Use a wrench or socket to tighten to 180 inch-pounds of torque.
DO NOT OVERTIGHTENED.
OPERATION
1. Read manual and follow instructions for fuel type, starting, etc.
2. The clutch will transfer maximum power after about two hours of normal operation. During this break-in period
clutch slippage may occur. The clutch should be kept free of oil or other moisture for efficient operation. Each
powerhead is tested at the factory, but is not operated for the full break-in period.
3. The earth auger unit should be operated no more than 20 degrees in any direction during continuous use and
limited to 30 degrees intermittently. Recommended for adequate lubrication and fuel delivery.
4. When digging in heavy soil, pump the earth auger unit with an up and down motion in the hole for every one
foot of depth.
5. Never run engine indoors. Exhaust fumes are deadly.
6. Do not use an earth auger in ice.
PRE-START CHECKLIST
1. Read and understand the engine manual and operator’s manual that came with your unit.
2. Fill oil sump or check oil level. Check oil level often during engine break-in.
3. Fill fuel tank. Use unleaded, regular gasoline.
4. Be sure spark plug wire is attached to spark plug.
Fig 1
