13
(4). Selection of the Fan Speed
go to the commissioning status, and then adjust the display in the temperature display area to 01
through the button “Mode” and adjust the setting of the fan speed, which comes to two options.
01: Three low fan speeds; 02: Three high fan speeds
Pressing the button “On/Off” also can quit this commissioning status but the set data won’t be memorized.
Under the commissioning status, if there is no any operation in 20 seconds after the last button
press, it will back to the previous state without memorizing the current data.
4 Installation and Dismantlement
4.1 Connection of the Signal Line of the Wired Remote Controller
●
Open the cover of the electric control box of the indoor unit.
●
Let the single line of the wired remote controller through the rubber ring.
●
Connect the signal line of the wired remote controller to the 4-pin socket of the indoor unit .
●
Tighten the signal wire with ties.
●
The communication distance between the main board and the wired remote controller can
be up to 20 meters ( the standard distance is 8 meters)
4.2 Installation of the Wired Remote Controller
1
PVC Pipe
3
4
5
2
Fig.14 Accessories for the Installation of the Wired Remote Controller
Table 3
No.
1
2
3
4
5
Name
Socket box
embedded
in the wall
Soleplate of the
Wired Remote
Controller
Screw M4X25
Front Panel of the
Wired Remote
Controller
Screw ST2.9X6
Sponge 20×20×2
Wired Remote Controller
XE71
(XE71-44/G)
