VIREO GEN3
OWNERS MANUAL - INDOOR UNIT
|
15
OPERATION OF WIRELESS REMOTE CONTROLLER (Continued)
NOTE
• The Auto Clean function will not work under
excessively hot or cold outdoor temperatures. If the
room is dusty, clean it once a month; if not, clean
it once every three months. After the Auto Clean
function is turned on, you can leave the room. When
Auto Clean is finished, the unit will enter standby
status.
• This function is only available for some models
including the Vireo GEN3 series.
Replacing batteries in remote controller
Fig 1
Fig 2
1.
Lift the cover along the direction of arrow (as shown
in Fig 1
).
2.
Take out the original batteries (as shown in Fig 1
).
3.
Place two (AAA 1.5V) dry batteries, and make sure
the position of “ + ” polar and “ – ” polar is correct (as
shown in Fig 2
).
4.
Reinstall the cover (as shown in Fig 2
).
NOTICE
• During operation, point the remote control signal
sender at the receiving window on indoor unit.
• The distance between signal sender and receiving
window should be no more than and there should be
no obstacles between them.
• Other electronics may interfere with the remote
signal remote controller should be close to indoor
unit during operation.
• Replace batteries with an equivalent model when
replacement is required.
• When you don’t use remote controller for a long
time, take out the batteries.
• If the display on remote controller is fuzzy or there’s
no display, replace batteries.
