Clean filter
2. Clean filter
Use clear water to wash it or dust catcher to
clean it. If the filter is very dirty (such as grease),
use warm water (45
℃
) dissolved with neutral
detergent to clean it, and then put it at the shady
place to dry it.
12
Spring
fastener
Spring
fastener
3. Install filter
After cleaning, reinstall the filter in reverse order.
Push it along the guide rails at both sides and
then press the left and right edges of the filter.
Refit the filter in the direction indicated by the
arrows.
1. Remove filter
Press the spring fasteners at both sides in the
direction indicated by the arrows.
Meanwhile, lift up the filter so that it is separat-
ed from the fasteners.
Pull the filter forward and remove it.
Check whether air inlets and air outlets are bl-
3.Check whether filter is clean.
Check whether mounting bracket for outdoor
unit is damaged or corroded . If yes, please
contact dealer.
4.
Do not remove the panel when cleaning it.
5.Check whether drainage pipe is damaged.
If there're other error codes, please contact qu-
alified professionals for service.
NOTICE
●
●
NOTICE
: Checking before use-season
1.
ocked.
2.Check whether air switch, plug and socket are
in good condition.
Disconnect power supply.
Clean filter and indoor unit’s panel.
Check whether mounting bracket for outdo or
unit is damaged or corroded. If yes, please
contact dealer.
NOTICE
: Checking after use-season
1.
2.
3.
Clean and maintenance
■
■
2.
WARNING
WARNING
Please contact qualified professionals for
service.
■
■
■
■
■
Error Code
Error code
F2
E8
Troubleshooting
C5
，
F0
，
F1
，
U8
，
H6
，
H3
，
E1
，
E5
，
E6
，
Notice for recovery
1.
Clean surface of indoor unit
When the surface of indoor unit is dirty, it is recomm-
ended to use a soft dry cloth or wet cloth to wipe it.
Many packing materials are recyclable mate-
The filter should be cleaned every three months .
If there is much dust in the operation environme-
After removing the filter, do not touch fins to
avoid injury.
Do not use fire or hair dryer to dry the filter to
avoid deformation or fire hazard.
When air conditioner status is abnormal, tempe-
rature indicator on indoor unit will blink to display
corresponding error code. Please refer to below
list for identification of error code.
rials. Please dispose them in appropriat e
recycling unit.
for the correct disposal method.
Turn off the air conditioner and disconnect the
power before cleaning the air conditioner to av-
oid electric shock.
Do not wash the air conditioner with water to
avoid electric shock.
Do not use volatile liquid to clean the air
conditioner.
Do not use liquid or corrosive detergent to clean
the appliance and do not splash water or other
liquid onto it , otherwise, it may damage the
plastic components , even cause electric shock.
nt, clean frequency can be increased.
contact local dealer or consultant service center
It can be eliminated after restarting the unit.
If not, please contact qualified professionals
for service.
If you want to dispose the air conditioner, please
NOTE
