Gree RVA-135R, Руководство пользователя по эксплуатации и установке

Страница: 15 / 20

STEP 2-INSTALLING THE CEILING ASSEMBLY
Make sure that you have properly matched the roof top air conditioner and interior ceiling
assembly.The following step by step instructions must be performed in the following sequence
to ensure proper installation.
2.
Remove the ceiling grille from the ceiling
assembly.
4.
Before lifting the ceiling assembly, pull
the fabric duct collar so it hangs out of
the way and does not get caught under
the ceiling assembly frame.
1.
Carefully take the ceiling assembly out
with the ceiling assembly).
of the carton (The remote control packed
3.
mounted to the roof top air conditioner,
plate (see Figure 5 and Figure 5-1 and
Figure 5-2).
Before the ceiling assembly can be
to the basepan of the roof top air
the fabric duct collar must be fastened
conditioner with 4 screws by upper duct
5.
Secure the ceiling assembly frame to the
gasket has been evenly compressed.
roof top air conditioner with the mounting
bolts(see Figure 5).You must start (thread)
themounting bolts by hand to avoid
cross-threading. DO NOT START THE
MOUNTING BOLTS WITH AN AIR GUN.
The mounting bolts should be tightened,
process is completed when the basepan
6.
opening (see Figure 5 and Figure 5-1).
Pull the fabric duct collar through the
the four corners to extend below the duct
ceiling assembly frame opening and pull
7.
6).Trim any excess fabric that may extend
beyond edge of bottom duct plate.
Fasten each side of the fabric duct with
fitting the bottom duct plate to the ceiling
assembly frame with 4 screws (see Figure
4 Screws
Figure 6
Frame
Bottom Duct
Plate
Figure 6-1
Please pay attention to
match the gap with the
riveted nut during installation
Upper Duct Plate
Fabric Duct
Figure 5-2
Figure 5-1
This Should Be
Assembled.
Installation Way of
Ventilation Opening Clamp
Indoor Unit
Outdoor Unit
4 Bolts
Figure 5
Gasket
Fabric Duct Collar
- 13 -