Gree N00600, Руководство по обслуживанию

Страница: 40 / 119

37
Technical Information
Service Manual
function. When child lock function is on, " " icon is displayed on
remote controller. If you operate the remote controller, the " "
icon will blink three times without sending signal to the unit.
4. Temperature display switchover function
Under OFF status, press " " and "MODE" buttons simultaneously
to switch temperature display between °C and °F.
5. Auto clean function
Under unit off status, hold "MODE" and "FAN" buttons
simultaneously for 5s to turn on or turn off the auto clean function.
When the auto clean function is turned on, indoor unit displays
"CL" . During the auto clean process of evaporator, the unit will
perform fast cooling or fast heating. There may be some noise,
which is the sound of flowing liquid or thermal expansion or cold
shrinkage. The air conditioner may blow cool or warm air, which
is a normal phenomenon. During cleaning process, please make
sure the room is well ventilated to avoid affecting the comfort.
NOTE:
● The auto clean function can only work under normal ambient
temperature. If the room is dusty, clean it once a month; if not,
clean it once every three months. After the auto clean function is
turned on, you can leave the room. When auto clean is finished,
the air conditioner will enter standby status.
● This function is only available for some models.
6. function
Press "MODE" and "SLEEP" buttons simultaneously to start
function.
function is for limiting power of the whole unit. Press this
button, the remote controller will circularly display as the
following:
blank
No Setting
● Maximum power limited under the mode is lower than that of
mode.
● If you want to cancel the power limiting function, press the
button till the icon in remote controller is not displayed.
● When the remote controller is turned off, power limiting
function is cancelled. If you want to activate the function, please
repress this button.
● If the current power is lower than the maximum power of
mode, then the power will not be limited after entering into such
mode.
● For the model with one outdoor unit and two indoor units, if
any one of indoor units enters into power limiting function, the
outdoor unit will enter into the set limiting power mode of indoor
unit; when two indoor units enter into power limiting mode, then
the power of outdoor unit will be limited according to the lower
power of the two indoor units.
NOTE:
● This function is only available for some models.
Replacement of batteries in remote controller
1. Lift the cover along the direction of arrow (as shown in Fig 1
①
).
2. Take out the original batteries (as shown in Fig 1
②
).
3. Place two 7# (AAA 1.5V) dry batteries, and make sure the
position of “ + ” polar and “ - ” polar is correct (as shown in Fig 2
③
).
4. Reinstall the cover (as shown in Fig 2
④
).
Fig.1
Fig.2
①
②
③
④
NOTICE:
● During operation, point the remote control signal sender at the
receiving window on indoor unit.
● The distance between signal sender and receiving window
should be no more than 8m, and there should be no obstacles
between them.
● Signal may be interfered easily in the room where there is
fluorescent lamp or wireless telephone; remote controller should
be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is
required.
● When you don’t use remote controller for a long time, please
take out the batteries.
● If the display on remote controller is fuzzy or there’s no display,
please replace batteries.