Dry Contact & 24 Volt Adaptor
18
5.2 Installation Procedure
(1) Twist off the screws used for fixing the cover, and then open the cover of
dry contact & 24 volt adaptor.
(2) Check whether the screws used for fixing the screws of main board is loose.
If yes, please tighten the screws until the main board is fixed.
(3) Attach the bottom case of dry contact & 24 volt adaptor at the installation
position (such as wall), and then use the screw to fix the bottom case and
the installation hole on the wall together.
Connect the wires to the corresponding wiring terminal by passing through
the rubber ring, and then tighten the screws on the contact to fix the
connection wire.
(4) Press the wires with wire-fixing clamp and then tighten the screws used for
fixing the wire-fixing clamp.
(5) Close the gateway cover of dry contact and then tighten the screws used
for fixing the cover.