12
Technical Information
Service Manual
1. ON/OFF button
2. MODE button
3. FAN button
6. SLEEP button
5. SWING button
Press this button to turn on the unit. Press this button again to turn off the unit.
Each time you press this button,a mode is selected in a sequence that goes from AUTO, COOL, DRY, FAN, and HEAT *,
as the following:
AUTO
COOL
DRY
FAN
HEAT
*
* Note: Only for models with heating function.
* Note: Fan speed under dry mode is low speed.
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, to , then back to Auto.
4.▲ / button
▲
▲
Press / button to increase/decreaseset temperature.In AUTO mode,set temperature is not adjustable.
▲
Press this button to set up & down swing angle.
▲
▲
Press this button again to cancel Sleep function. Under Fan and Auto modes, this function is unavailable.
7.
TEMP button
Press this button, you can see indoor set temperature, indoor ambient temperature on indoor unit’s display. The setting
on remote controller is selected circularly as below:
no display
8.
TURBO
button
9. I FEEL button
10.
Timer
button
11. X-FAN button
11. Light button
press this button to activate / deactivate the Turbo function.
Under ON status, press this button to set timer OFF; Under OFF status, press this button to set timer ON.
Press this button to start I FEEL function and " " will be displayed on the remotecontroller. After this function is set, the
remote controller will send the detectedambient temperature to the controller and the unit will automatically adjust theindoor
temperature according to the detected temperature. Press this button againto close I FEEL function and " " will disappear.
When I FEEL function is turned on, the remote controller should be put within the area where indoor unit can receive the
signal sent by the remote controller.
● Press this button once and the characters of HOUR ON (OFF) will flash to be displayed. Meanwhile, press "
▲
" button
or "
▲
" button to adjust timer setting (time will change quickly if hoiding "
▲
" or "
▲
"button). Time setting range is
0.5~24hours. Press this button again to confirm timer setting and the characters of HOUR ON (OFF)will stop flashing.
If the characters are flashing but you haven’t press timer button,timer setting status will be quit after 5s.If timer is confirmer,
press this button again to canceltimer.
Press this button in COOL or DRY mode to turn on X-fan function.
When this function is started up, indoor fan will still operate at low fan speed for a while after turning off the unit by remote controller.
Press this button to turn on the display's light and press this button again to turn off the display's light.
