45
Installation and Maintenance
Service Manual
3.6 Swing Setting
Swing On: Press Function under on state of the unit to activate the swing function. In this case, will blink,After that,press Enter/Cancel
to make a confirmation.
Swing Off: When the Swing function is on, press Function to enter the Swing setting interface,with blinking. After that, press Enter/
Cancel to cancel this function. Swing setting is shown as Fig.3.6.1.
Notes:
(1)Sleep, Turbo or Blow setting is the same as the Swing setting.
(2)After the setting has been done, it has to press the key “Enter/Cancel” to back to the setting status or quit automatically five seconds
later.
3.7 Sleep Setting
Sleep on: Press Function under the On state of the unit till the unit enters the Sleep setting state. After that, press Enter/Cancel to
confirm this setting.
Sleep off: When the Sleep function is activated, press Function to enter the Sleep setting status. After that, press Enter/Cancel to cancel
this function.
In the Cooling or Dry mode, the temperature will increase by 1°C(1~2°F) after the unit runs under Sleep1 for 1hr and 1°C(1~2°F) after
another 1hr.After that, the unit will run at this temperature.
In the Heating mode, the temperature will decrease by 1°C(1~2°F) after the unit runs under Sleep 1 for 1hr and 1°C(1~2°F) after another
1hr. After that, the unit will run at this temperature.
Turn off the unit,without Swing
function activated
Press Function repeatedly unitll
go to the Swing setting status
Press Enter/Cancel to activated the Swing
function
Press Enter/Cancel to cancel this
setting
Fig.3.6.1 Swing Setting
Press Function repeatedly unitll go to the
Swing function again
Timer range: 0.5-24hr. Every press of ▲or ▼ will make the set time increased or decreased by 0.5hr. If either of them is pressed
continuously, the set time will increase/ decrease by 0.5hr every 0.5s.
