Auto
Cool
Dry
Heat
●
●
●
●
●
●
8
1
ON/OFF button
Press this button to turn on the unit. Press this button again to turn off the unit.
2
MODE button
Press this button can your required operation mode in turn. Corresponding indicator
will be on.
Fan
Only
Auto:
Under this mode, the unit will operate automatically according to ex-factory
setting. In this case, set temperature cannot be adjusted.
Cool:
Under this mode, air conditioner operates under cooling mode. Cooling
indicator will be on. Press “Fan Speed” button can adjust the fan speed.
Dry:
Under this mode, the unit runs in low fan speed for dehumidification and the
corresponding indicator is on; under dry mode, the fan speed cannot be adjusted.
Fan Only:
Under this mode, air conditioner will not cool or heat, only blow wind.
Fan indicator will be on. Press “Fan Speed” button can adjust the fan speed.
Heat:
Under this mode, air conditioner operates under heating mode. Press “Fan
Speed” button can adjust the fan speed.(Cooling only unit won’t receive heating
mode signal. If setting heat mode with remote controller, press ON/OFF button
can’t start up the unit.)
Pressing “+” or “-” button once will increase or decrease set temperature by 1°F(°C).
Hold “+” or “-” button for 2s, set temperature on remote controller will change
quickly. Release the button after your required set temperature is reached.
Under timer setting status, after each pressing of “+” or “-” button, time will increase
or decrease 0.5h. Hold “ + ” or “-” button, 2s later, time displayed on dual-8 nixie
tube will change quickly. Loosen the button until the time is reached to your set
time.
This is a general use remote controller, it could be used for the air conditioners
with multifunction; For some function, which the model doesn't have, if press
the corresponding button on the remote controller that the unit will keep the
original running status.
Introduction for buttons on remote controller
Note:
●
3
+ / -
button
●
