Cassette Type Fan Coil Unit
5
5.2 Installation of the unit
(1) Schematic diagram of installation (as Fig.5).
H
>20
Unit:mm
Fig.5
(2) Select install location of the unit
1) Obs
truct should put away from the intake or outlet vent of the unit so that the airflow can be
blown though all the room.
2) Make sure that the installation had accord with the requirement of the schematic diagram of
installation spaces.
3) Select the place where can stand 4 times of the weight of the unit and would not increase the
operating noise and oscillate.
(3) The horizontally of the installation place should be guaranteed.
(4) Select the place where is easy to drain out the condensate water.
(5) Make sure that there are enough space for care and maintenance. Make sure that the height
between the unit and ground is above 2500 mm.
(6) When installing the suspender bolt, check if the install place can stand the weight 4 times of the
unit’s. If not, reinforce before installation.
There will be lots of lampblack and dust stick on the fan, heat exchanger and water pump in
dining room and kitchen, which would reduce the capacity of heat exchanger, lead water leakage
and abnormal operation of the water pump.
The following treatment should be taken under this circumstance:
(1) Ensure that the smoke trap above cooker has enough capacity to obviate lampblack to prevent
the indraft of the lampblack by the unit.
(2) Keep the unit far from the kitchen so that the lampblack would not be indraft by the unit.
Important notice
To the good performance, the unit must be installed by professional personnel according with
this instruction.
