16
Technical Information
Service Manual
1. ON/OFF button
2. MODE button
3. FAN button
6. SLEEP button
5. SWING button
Press this button to turn on the unit. Press this button again to turn off the unit.
Each time you press this button,a mode is selected in a sequence that goes from AUTO, COOL, DRY, FAN, and HEAT *,
as the following:
AUTO
COOL
DRY
FAN
HEAT
*
* Note: Only for models with heating function.
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, to , then back to Auto.
4.▲ / button
▲
Press this button to set up & down swing angle.
Auto
* Note: Fan speed under dry mode is low speed.
This function indicates that moisture on evaporator of indoor unit will be blowed after the unit is stopped to avoid mould.
Having set X-FAN function on: After turning off the unit by pressing ON/OFF button indoor fan will continue running for a few
minutes. at low speed. In this period, Hold fan speed button for 2s to stop indoor fan directly.
Having set X-FAN function off: After turning off the unit by pressing ON/OFF
button, the complete unit will be off directly.
X-FAN function Hold fan speed button for 2s in COOL or DRY mode, the icon “ ” is displayed and the indoor fan will continue
operation for a few minutes in order to dry the indoor unit even though you have turned off the unit. After energization, X-FAN
OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
●
●
●
Under Cool, Heat mode, press this button to turn on Sleep function. Press this button again to cancel Sleep function.
Under Fan
、
DRY and Auto modes, this function is unavailable.
▲
Press / button to increase/decreaseset temperature. In AUTO mode, set temperature is not adjustable.
▲
▲
When setting Timer On or Timer Off, press "▲" or " " button to adjust the time.
7.
TEMP button
Note:
● Outdoor temperature display is not available for some models. At that time, indoor
unit receives " " signal, while it displays indoor set temperature.
Press this button, you can see indoor set temperature, indoor ambient temperature on indoor unit’s display.
The setting on remote controller is selected circularly as below:
no display
