4
Operating Instructions and Parts Manual
80134
ROTARY TOOL
06/15
2015 GREATNECK
WARNING
Double insulated tools are equipped with a polarized
plug (one blade is wider than the other). This plug will
fit in a polarized plug only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install a polarized
outlet. Do not change the plug in any way. Double
insulation eliminates the need for the three-wire
grounded power cord and grounded power supply
system.
OPERATING INSTRUCTIONS
WARNING
Ensure you read, understand and apply safety
instructions before use.
1. Always inspect, maintain and operate in
accordance with ANSI safety code for power tools
and other local safety codes and regulations.
2. Use clamps or other practical ways to secure and
support the work piece to a stable platform.
3. Do not force the tool. Use the correct tool for the
job.
4. Disconnect the plug from the power source before
making any adjustments, changing accessories or
storing the tool.
5. Check for misalignment or binding moving parts,
breakage of parts and any other condition that
may affect the tool’s operation. If damaged, have
the tool serviced before using.
6. Use only accessories that are recommended by
the manufacturer for your model.
7. Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its own cord.
8. Always make sure the work surface is free from
nails and other foreign objects.
9. Never hold the work piece in one hand and the
tool in the other hand when in use. Never place the
hands near or below the cutting surface.
10. Never lay work piece on hard surfaces like
concrete, stone, etc.
11. After changing the bits and accessories or making
adjustments, make sure the collet nut and any
other adjustment devices are securely tightened.
12. Always use the correct collet size.
13. Always check accessory bits, grinding stones,
cut-off wheels, etc. for damage before each use.
14. Never use dull or damaged bits. Sharp bits must
be handled with care.
15. Never touch the bit during or immediately after
use.
16. The rotary tool is wired at the factory for 110–120V
operation. It must be connected to a 110–120V,
15A time delayed fuse or circuit breaker. To avoid
shock or fire, replace power cord immediately if it
is worn, cut or damaged in any way.
17. Avoid accidental starting. Be sure switch is OFF
before plugging in.
18. Remove adjusting keys or wrenches before turning
the tool ON.
NOTE:
Most commonly used bits and accessories
with 1/8” and 3/32” shanks will fit this tool. Rotary Tool
accessories, such as a drill press designed for other
rotary tools, may not fit this tool.
WARNING
If any part is missing or damaged, do not plug the
Rotary Tool into the power source until the missing or
damaged part is replaced.
WARNING
To avoid fire or toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner or similar highly
volatile solvents to clean the tool.
