GREAT PLAINS YP-425, Руководство оператора

Страница: 123 / 134

YP-425, 625, 825, & 1025-A3P Table of Contents Index Appendix C - Initial Setup 119
2018-07-23 Table of Contents Index 401-652M
Initial Marker Setup (Option)
Marker Speed Adjustment
Overhead Sharp Object and Crushing Hazards:
Never allow anyone near the planter when folding or
unfolding the markers. You may be injured if hit by a folding or
unfolding marker. Markers may fall quickly and unexpectedly
if the hydraulics fail. Marker discs may be sharp.
Refer to Figure 106 and Figure 107
Adjust folding speed for dual markers with hex
adjustment screws on the sequence valve body. The
valve sequence body is top center of main tool bar.
Loosen jam nuts before making adjustments.
There is one adjustment screw for raising speed and
one for lowering speed . You can identify adjustment
screws by markings stamped in valve body.
Turn adjustment screws clockwise (S: slower) to
decrease folding speed and counterclockwise (F: faster)
to increase folding speed.
With tractor idling at a normal operating speed, adjust
marker folding to a safe speed. Excessive folding speed
could damage markers and void the warranty.
After adjusting the folding speed, tighten jam nuts on hex
adjustment screws to hold settings.
Marker Extension
Marker extension needs to be adjusted once for the initial
YP-425, 625, 825, & 1025-A3P planter setup, and later
only if changing row spacing (including row shut-off for
single-row operation on a twin-capable planter).
1. Move the planter to a location where both markers
may be safely unfolded. Lower the planter. Pull
forward and lower the row units into the ground.

Due to the relatively steep arm angles of short
markers, extension measurements are likely to be
incorrect if the main tool bar is not at normal operating
height (26 inch).
2. Tilt up and unfold one marker.
Figure 105
Marker Sequence Valve Location
31007
1
2
Figure 106
Marker Speed Adjustment
14048
F
S
S
1
2
U
D
B
F
R
L
Figure 107
Marker Extension
31039
E