06/12/2019
401-754M
YP625PD
Adjustments
46
Marker Adjustments (Option)
See also:
•
marker speed and marker extension
•
” on page 32; and,
•
marker shear bolt and marker hydraulic bleeding
Marker Disk Adjustment
Sharp Object Hazard:
Use caution when making adjustments in this area.
Marker disks may be sharp.
1. To change angle of cut, and the width of the mark,
loosen
1
2
-inch bolts holding the disk assembly.
For a wider mark , increase the angle of the
marker with respect to the tube . For a narrower
mark , reduce the angle.
Do not set a marker angle wider than needed to make
a useful mark. Excess angle increases wear on all
marker components.
2. Tighten bolts .
Direction of travel tends to drive the disk angle to
Wide. If bolts are not tight enough, or loosen over
time, disk slips into the Wide mark configuration.
Gauge Wheel Height Adjustment
The YP625PD is factory pre-set for planting on 18 cm
beds.This operating height can be reduced by 5 cm, to
13 cm, but relocating the gauge wheel axles.
For operation on flat ground, do not make this
adjustment. Instead adjust the lift cylinder mounts.
Appendix C - Flat Ground Planting
1. Raise the planter. Support the frame with jacks or
stands. Retract the lift circuit to raise the tires off the
ground.
2. Remove the axle bolts from the lower holes .
3. Re-install the bolts and axles in the upper holes.
Sharp Overhead Object and Pinch/Crush Hazards:
Never allow anyone near the planter when folding or
unfolding the markers. Markers may fall quickly and
unexpectedly if the hydraulics fail. Anyone beneath may be
injured if hit by an unfolding marker, or caught in a folding
Null4:
Figure 41
Marker Disk Angle
11757
T
2
1
N
W
T
Null4:
Figure 42
Axle Height
31734
4
3
