GREAT PLAINS Turbo Max 3500TM, Инструкция по сборке

Страница: 12 / 76

Great Plains | 586-537Q-ENG | 04/26/2019 Table of Contents Index 8
3500-4000TM Table of Contents Index Assembly
clean, packing the bearings with grease and following the
steps closely to assure the correct assembly of components.
Refer to Figure 6
9. Once the bearings are packed with grease, slide them (one on each side) into pre-installed bearing cup of torque tube
.
Slide seals into torque tube . Slide spindle sleeve , one into inside of torque tube , through seal and bearing ,
the other one over the pivot spindle . Slide the LH and RH walking beams over torque tube in orientation shown with
spindle tubes offset towards top. Be sure holes are aligned and slide pivot spindle through from outside of machine. Secure
with two 2.25 x 1.50 x 10ga machine washers and 1
1

2
slotted nut . Tighten 1
1

2
slotted nut down snug, then back off
1

8
to
1

4
turn, enough to align slot with hole in pivot spindle and install
1

4
x 3 cotter pin . Bend cotter pin over to secure. Be
sure walking beam will pivot freely but there should be no endplay.
10. Grease zerk sparingly but do not over grease.
11. Slide hub/spindle assembly into walking beam and align holes. Secure with
3

4
x 5 hex bolts and
3

4
top lock nut.
12. Attach tire/wheel assembly with
3

4
flange nuts .
13. Tighten all bolts with lock nuts snug, but do not torque. The rest of the bolts may be tightened to specs, See “ Torque Values
Chart ” on page 38.
Wing Stops & Fold Brackets
Refer to Figure 7
14. Attach front and rear fold brackets to center frame
plates with
3

4
x 2 hex bolts ,
3

4
lock washers and nuts.
15. Install double block tees in locations shown below and
the smv post to back of rear fold bracket with
5

16
x
1
1
13
2
13
3
13
2 1
5 4
13
5
6 7 7
8
4
14
9
4 10
11 12
12
2
1
6
10
3
2
1
4
7
9
11
11
9
13
14
U
D
F
B
L
R
8
5
3
Figure 6
Center Transport
43137
1 2
3
4
5
2