GREAT PLAINS TSF1080, Руководство оператора

Страница: 44 / 94

08/01/2018 Table of Contents Index 500-641M
TSF1080, TSF1090, TSF1280 & TSF1290 Table of Contents Index Operations 40
Plumbing Overview
Refer to Figure 28
A basic knowledge of how the sprayer is plumbed helps
you understand how to operate your Great Plains
Sprayer. Throughout this manual, the components on
this diagram are described with the terminology labeling
these components.
Five of the valves are labeled on the sprayer decals.
Other key components are:
Valves operate by moving their handles to point at the
function on the decal, or toward the pipe desired on an
otherwise unmarked selector valve. Shut-off valves are
open when the handle is parallel to the piping, and
closed when the handle is perpendicular.
Fluid is drawn from the main tank via the sump
and passes through the pump. The illustration shows
an Ace hydraulic pump, but your pump may be PTO or a
non-standard installation.
From the pump, fluid passes through the solution
Whirlfilter® ,
which filters out or grinds up all
undissolved chemical and solid particles. The fluid then
passes through both the flow meter
and the bypass
control butterfly valve .
The bypass control butterfly valve controls how much
fluid goes to the boom. This is regulated by the Raven
SCS 450 controller. The fluid passes through the flow
meter
and proceeds to the 5-Way Boom Manifold
valves. If a boom valve is on, the fluid passes to its
respective boom section and is sprayed out the individual
nozzles. See page 84 for a layout of the boom plumbing.
The agitation is set by adjusting the agitation pressure
valve
while the pump is at operating speed. Refer to
Application Guide to adjust the agitation.
The optional inductor provides convenient
pump-driven loading of concentrates into the main tank.
There are tank shut off valves ( - ) at each inlet and
outlet. Use these to prevent spills and isolate any leaks.
To operate a correctly connected hydraulic pump, push
the hydraulic lever in the “down” position. When you want
to stop the pump, put the hydraulic lever in the “float”
position.
Do not move the hydraulic lever to the neutral position while
the hydraulic pump is running. To do so may cause damage to
the hydraulic pump.
Agitator Selector Valve
Pump Inlet (Tank) Selector Valve
Fill/Spray Selector Valve
Product Valve (Tank Fill vs. Induct)
Inductor Valve (On/Off)
Figure 27
Valve Setting Decal
838-700C
1
2
3
4
5
Main Tank
Flush Tank
Main Tank Sump
Pump
Solution Whirlfilter®
Flow Meter
Bypass Control Butterfly Valve
5-Way Boom Manifold Valves
Agitation Gauge
Inductor
Main Inlet Quick Connect
Main Inlet Filter
Flush Tank Inlet Quick Connect
Manual Throttle Valve
Agitator Inlet Shutoff Valves (Normally Open)
Main Inlet Shutoff (Normally Closed)
Flush Tank Inlet Shutoff (Normally Closed)
Main Tank Sump Shutoff (Normally Open)
Whirlfilter Cleanout Shutoff Valve (Normally Closed)
Inductor Outlet/Tank Inlet Shutoff Valve (N.Open)
10
11
12
13
14
15
16
17
18
19
20
21
22
23
30
31
32
33
34
35
10 12
13
14
15
16
16
15 17
1
15
30 35